Tech Support:
www.steppir.com/support
⚫
Tel: 425.453.1910
⚫
Page 57
0.25”
GAP
FIG. 6.08
FIG. 6.09
0.25”
Attach the sweep couplers to the plastic sweep tubes
•
Refer to
figure 6.06
during the following steps for an overview of the assembly process.
•
Each of the sweep coupler halves (PN 10
-
1155
-
01) will have a notch in the mold on one side
marked with silver sharpie.
IT IS CRITICAL THAT THESE NOTCHES ARE POINTING TOWARDS THE
SWEEPS OR THEY WILL NOT WORK PROPERLY.
See
figure 6.07
for the location of the mark. Be
certain that each half of the coupler has the mark facing the sweep tube!
•
Place the coupler halves on the end of the plastic sweep tubing as shown in
figure 6.08
. Insert four
of the 6
-
32 x
2”
socket head screw (PN 60
-
0186) with washer (PN 60
-
0016). Place the screws so
that the threaded portion of the screw is facing downward.
BE SURE THAT THE DRAIN HOLES FOR
THE PLASTIC SWEEP TUBE ARE POINTING DOWNWARD BEFORE INSTALLING THE COUPLERS
.
Apply anti
-
seize to the threads and place the Nylock nuts on. Tighten using a
5/16”
wrench to hold
the nut and the provided
7/64”
Allen Key to turn the screw. Tighten until there is approximately a
0.25”
gap between the two coupler halves as shown in
figure 6.09
.
•
Repeat the previous steps on the other side of sweep tube.
•
The couplers are designed to re
-
form the plastic sweep to
lock them in place. Do not be alarmed if there is a need to
exert a fair amount of force when tightening the screws—this
is necessary in order to re
-
form the plastic sweep tubing.
FIG. 6.07
40/30 Loop Assembly
CHAPTER SIX
SECTION 6.1
FIG. 6.07
Key
QTY
Part Number
Description
A
2
60-0190
Washer, 6-32, Flat, SS
B
6
60-0186
Screw, 6-32 x 2”, 18-8 SOC Head Cap
C
6
60-0014
Nut, 6-32 Nylock
D
4
60-0016
Washer, 6-32, Flat
E
1
10-1503-21
Fiberglass Rod, 3/8” x 31-3/4” long, black
F
2
10-1155-01
Sweep Clamp, SCH-160 Clamp Half
G
1
10-1156-01
Poly Sweeps (160psi)
H
1
10-1013-02
Telescoping Pole, 18 foot 4 section
I
1
09-0001
Electrical Tape 3/4”
J
1
09-0007
Silicone Wrap, blue, 1/2” x 10mil
K
1
09-0013-CUT
3M adhesive grip tape, 1” x 2-1/4”