Tech Support:
www.steppir.com/support
Tel: 425.891.6134
Page 64
CHAPTER EIGHT
SECTION 8.1
OPTIONAL 40/30 LOOP TRUSS KIT (continued)
ATTACH THE TRUSS COUPLERS
There are two pieces to the truss couplers PN 10-1510-01) as shown in
figure 8.10
. The couplers are mount-
ed on each side of the loop, located at the outer joint of the telescoping poles as shown in
figure 8.11
. The
truss coupler butts up against the edge of the polyolefin heat shrink.
There are nut trays molded on one side of the truss coupler as shown in
figure 8.12
. These are handy for
holding the #6 Nylock nut (PN 60-0014) when tightening, but you will need to hold your finger over the nut
to keep it from spinning when you thread on each of the #6 x 7/8” pan-head machine screw (PN 60-0014-
01) as shown in
figure 8.13
. Only the outer four holes of the truss coupler are used for attaching it as shown
in
figure 8.14
. Note that the top portion of the coupler (the portion facing skyward) has a hole, but this is
also not used as shown in the second picture of
figure 8.14
. Align the truss coupler so that it is parallel to
the telescoping pole and tighten each nut.
The Dacron truss cord is provided in a single piece and will need to be trimmed as you progress with the in-
stallation of the end trusses. Thread the Dacron cord through the truss coupler, leaving approximately ten
inches of truss cord as shown in
figure 8.15
. Tie four half-hitches and leave approximately four inches of
leader as shown in
figure 8.16
.
Figure 8.17
shows the proper way to tie a half-hitch. When finished, apply
electrical tape so that the leader of the Dacron rope is secured to the truss line as shown in
figure 8.18
.
FIG. 8.10
FIG. 8.11
FIG. 8.12
1
2
3
4
Dacron Rope
FIG. 8.13
FIG. 8.14
FIG. 8.15
FIG. 8.16
FIG. 8.17
FIG. 8.18
