SSD10000S - SSD10000S/3PH
9
f) Located on the control panel door/cover.
• Do not climb on the generator - dents may cause overheating of the acoustic lining.
• Keep well clear of any moving parts on the generator at all times.
• Keep children and pets away from the generator and operating area.
• Test safety features often, emergency stop button and RCD (residual current device).
• Keep the generator canopy doors shut while running and locked if possible.
Do not remove covers and attempt to work on the generator while the engine is running.
Check the rating and electrical safety of the load before connecting the generator.
Equipment should never be connected that in total exceeds the specified rating of the generator.
• Do not cover the generator as this can obstruct air inlet and outlets on the canopy which can cause the
generator to overheat and cause permanent damage..
The electricity produced by an engine driven generator is very similar to mains AC electricity and should be
treated accordingly.
g) Located on the canopy roof near the
control panel.
Installation of the generator as a standby or secondary power source should only be undertaken by a fully
qualified electrician using the appropriate means of isolation from the mains supply. Installation must comply
with all applicable laws, electrical codes and wiring regulations.
The generator should always be operated on level ground and be able to bear its weight. Ensure the
generator canopy is not obstructed to allow cool air to enter the set and hot expelled air to escape.
Temperature Range
Auxiliary Power
Operating Environment
Personal Safety
A temperature range between -15
⁰C and +45⁰C are the normal limits of operation. Operating outside the
range will require additional modifications.
f)
g)
Summary of Contents for SSD10000S
Page 37: ...Blank Page...
