SDXI-U2 Serial ASCII Data Exchange Interface
General Description V1.15
© Stemin GmbH
•
SDXI U2 Protocol Description V1.15.doc
•
page
9 of 15
2.3 Device Configuration
2.3.1 Set Baudrate („U2DM<d>COM<c>BD=<bd>“)
Dir
Telegram
Description
U2DM<d>COM<c>BD=<bd><CR>
This command sets the baudrate of the specified
COM port of the device:
<c> = COM port
0: COM port actually connected to the
device
1: COM 1 of the device
2: COM 2 of the device
<bd>= Baudrate
24
(=2400 Baud)
48
(=4800 Baud)
96
(=9600 Baud)
192
(=19200 Baud)
384
(=38400 Baud)
576
(=57600 Baud)
1152 (=115200 Baud)
Note:
these settings can not be changed, they are fix:
Parity:
no
Databits:
8
Stopbit(s):
1
U2DM1COM0BD=1152<CR>
<p1>: Baudrate = 1152
(the new device baudrate is set to 115200
Baud)
---
no device response
---
no device response
2.3.2 Set Remote Interface („U2DM<d>DRI=<s>“)
Dir
Telegram
Description
U2DM<d>DRI=<s><CR>
This command enables or disables the remote
interface of the device. For a remote control of the
device, it is necessary to send this command first
to enable the complete remote control
functionality:
<s>: 1 = enable the remote interface
0 = disable the remote interface
U2DM1DRI?<CR>
Request the state of the remote interface
U2DM1DRI=0<CR>
returns the state of the remote interface:
<s>: 0 = remote interface disabled
U2DM1DRI=1<CR>
Enables the remote interface
<s>: 1 = enables the interface
U2DM1DRI=1<CR>
Returns the state of the remote interface:
<s>: 0 = remote interface is enabled
