Домкрат гиДравлический поДкатной
12
en
g
SAfETy INSTRUcTIONS
The dolly-type jack is high hazard equipment. To avoid the risk of injuries and damage to property, read
these operating instructions completely and familiarize yourself thoroughly with the product.
This jack may be used only for load lifting. Never use this jack for the raised load pulling. Pulling of the jack
with lifted load is prohibited.
This jack should be used only on smooth, hard and level surface capable of sustaining the load. Use on
other surfaces may cause load to drop.
After lifting, the load should be fixed with the help of special props or supports designed to hold the rated
load weight and reliably keeping it in the lifted position.
It is prohibited to stay or carry out works under the lifted load held only by the jack. Stay away from moving
hinged joints of the jack.
Never exceed the maximum rated lifting capacity of the jack. Overload of the jack may result in its failure
and cause personal injury.
The safety valve is adjusted for safe operation of the item with maximum rated load of 2 tons. It is prohibited
to change factory settings of the safety valve at your own discretion; it may cause failure of the item and
personal injury.
It is permitted to use only the components and adapters recommended for use by the manufacturer.
It is prohibited to disassemble the jack on your own initiative, as well as make changes and modifications
in the construction of the jack.
Failure to heed these rules may result in causing personal injury and failure of hydraulic equipment.
The operator working with the jack should be cautious, competent, should have passed a training course
and have a qualification in safety techniques when working with servo motors and their moving parts,
and should preserve safety measures while operating the jack.
All warning labels should always be legible and these operating instructions should be kept intact during
the whole service life of the jack.
BEfORE USE
Test the jack. Close the release valve by turning it with the help of the handle clockwise until it is firmly
closed. Insert the handle into the pump unit handle sleeve and make sure that it is reliably fixed in the slot.
Pay attention that in this model the sleeve is rotatable by 180˚ for ease of operation. Pump handle several
times up and down; when this is done, the lifting arm of the jack should start rising. To lower the lifting
arm, turn the release valve with the help of the handle counterclockwise by no more than three turns, and
when the lifting arm is lowered completely, close the release valve by turning its handle clockwise as far
as it goes.
ATTENTION!
Operation of the jack in the wrong position, on the side, in the upside down position
is not allowed.
