2
Please read and make sure you understand all instructions and safety warnings. Electrical
cables, if not installed correctly or are damaged, can cause a fire, shock and arcing hazard.
1. Installation must be in compliance with National Electrical Codes (NEC) and the Canadian
Electrical Code (CEC).
2. Use 30-mA ground fault protection (GFCI) on each heating cable branch circuit for maximum
protection.
3. Use only fire-resistant insulation, such as fiberglass or preformed foam. Do not embed heating
cable in the insulation.
4. Use fiberglass or aluminum adhesive foil tape when attaching cable to pipe. Do not use wire or
metal clamps.
5. Before installing or servicing, disconnect power at service panel.
6. Do not twist cable during installation.
7. Do not install this heating cable under roofing material.
8. Do not expose this heating cable to temperatures above 185°F (85°C), as this will damage the
cable.
9. Do not use extension cords.
IMPORTANT INSTRUCTIONS
WARNING: Do not use damaged heating cables, power cord or plug.
Remove and replace immediately to prevent a fire, shock or arcing hazard
SAVE THESE INSTRUCTIONS
NOTE: Accessories are sold separately.
INSTALLATION
PIPE
ACCESSORIES REQUIRED
SSFR-ALUTAPE
Aluminum adhesive foil tape
Insulation
