INSShuT1_0316
For further information or to consult this guide online, please visit our website at
www.stelpro.com
Stelpro DeSign inc. | Saint-Bruno-de-Montarville | Quebec | J3V 6l7
Before installing and operating this product, the user and/or installer must read, understand and follow these instructions and keep them handy for future
reference. If these instructions are not followed, the warranty will be considered null and void and the manufacturer deems no further responsibility for this product.
The following instructions must be adhered to in order to avoid personal and serious injuries, property damages and potentially fatal electric shocks.
Switch off the power at the circuit breaker/fuse before installing, repairing and cleaning the unit.
Make sure the unit is appropriate for the intended use (if needed, refer to the product catalog or a representative).
wARNINg
coMMERcIAl ANd INduSTRIAl uNIT hEATER | Shu SERIES
BUilt-in thermostat installation
ShuT1 SERIES
SINglE polE ThERMoSTAT
1. Remove access cover to control box of heater.
2. Install the thermostat on the bracket. FIG. 1
3. Connect the two black wires supplied with the kit to the thermostat
terminal. FIG. 2
4. Pass the capillary bulb through the bushing and put the plastic
bushing on the hole. FIG. 3
5. hold the bulb in place with plastic strapping which locks itself on
the hole. FIG. 4
6. Install thermostat bracket on holes provided. use the screws (2)
provided with the kit. FIG. 5
7. Connect one black wire from the thermostat into the terminal block
C and the other black wire into the terminal block 1, see electrical
diagram. FIG. 6
8. Reinstall access cover to control box.
fig. 1
fig. 2
fig. 4
fig. 6
fig. 3
fig. 5
