17
INSSCV1217
METAL SCREW #8
2x
PLATE & CONNECTOR ASSY
REMOVE RECTANGLE KO PLATE
CONTROL BOX REMOTE INSTALLATION
When the air handler is used with a remote control box (model # SCV-E-xx2&3x), both assemblies are installed remotely from one another with a
maximum distance in between determined by the length of cable harness linking them both (HAR-091 for 120’’ long and HAR-092 for 48’’ long).
This alternate configuration does not require any changes to the unit’s high voltage wiring (refer to Fig. 9).
The installer must remove the rectangle knock-out plate located on either side (left and right) of the cabinet and install the plate and connector
assembly with two metal screws, as shown in Fig. 18 below.
The installer must determine the location of the remote control box and install it on the wall with four (4) screws, as shown in Fig. 19.
FIG. 18
FIG. 19
