steinert UME 115 130 C, Instructions Manual

Page: 36 / 86

Over-belt magnetic separator UME … C
Installation and commissioning
36
GB_UME 75-135 ... C-03-US
8.2 Installation
WARNING! Incorrect suspension!
Risk of injury.
Never use a chain suspension as a loop
between two attachment points.
Over belt magnetic separators are intended for use within an
overall system.
Plant parts in the area of the magnetic field must be made of
nonmagnetic material.
−
See chapter "Use of nonmagnetic material".
Ensure that for a 4-point suspension the entire load plus a
safety margin can be supported by 2 of the 4 upper attachment
points.
−
Specify the working load limit of the upper suspension points
taking into consideration the load to be suspended, the
angle the lifting gear and the overhang length.
For belt speeds greater than or equal to 1.6 m/s, an impact wall
or protective wall for limiting the discharge width must be fitted.
The direction of running of the discharge belt of the over belt
magnetic separator must match the direction of the arrow
applied to the magnet, viewed from below the machine.
When suspending the over belt magnetic separator, it can be
rotated through 180° to change the discharge direction.
−
Reversing the polarity of the drive motor to change the
direction of rotation is forbidden.
If installed with a transverse suspension, the over belt magnetic
separator can be deployed at a maximum inclination of 25°
without problem.