steinert KM 3100 SE, Operating Instructions Manual

Page: 8 / 10

SAFETY REGULATIONS

The belt guard must be reclosed after each change of V-belt position, motor does not run if vee-belt cover
is not properly closed

Before the machine is switched on :
Turn Potentiometer always to “0”

Spindle speed must be checked against the maximum permissible workpiece diameter.

Large, out-of-balance workpieces must be machined at minimum speed,
cut them by a bandsaw octagonal to decrease out-of-balance

All clamping levers i.e. spindle-/tailstock, tool rests etc must be tightened before beginning to work,

any operating pins /keys must be removed from chucks or spindle!
MAINTENANCE

The machine requires no special maintenance.

The bearings are sealed at both sides and are life-time protected with high performance grease.

The Angular Ball bearing retainer ring strengthened from fiber glass Polyamid is applicable for continious
temperatures up to +120°C.

A temperature of 70° is uncritical as per manufacturers information.

Bright parts should be oiled occasionally to prevent corrosion, f.e. Balistol or similar product can also be used.

Expecially if constantly green and wet wood is turned and to safe the life time of your machine
clean the machine immediately after turning, wipe dry bright parts and oil them i.e. lathe bed, spindle etc.

Indexing pin, excenter shaft of tool rest, quill and spindle should be oiled between 4-6 month
to ensure true running and prevend seizing up.
ACCESSORIES, ATTACHMENTS, OPTIONS, COPYING UNITS
We refer to our Accessory Catalogue and our web-page www.drechslershop.de
Drechselzentrum Erzgebirge - steinert®
Heuweg 4
09526 Olbernhau
Tel./Phone:
+49 (0)37360-6693-0
Fax/Fax: +49 (0)37360-6693-29
mail
info@drechslershop.de
shop www.drechslershop.de
webseite www.drechslershop.de/drechselbaenke/killinger