CHANGING TURNING DIRECTION = ROTATION OF SPINDLE
to righthanded rotation, clockwise
correct turning direction is anticlockwise, lefthanded rotation
the flip switch/or selector for forward/reverse switch is integrated at the movable box.
For adjusted turning direction watch the sticker on the headstock
when changing the turning direction the inverter will automatically slow down the speed:
spindle starts slow in opposite direction, speed increases again as adjusted before
Caution to meet safety regulations
adjust the slowest spindle speed before changing the spindle direction.
Chucks may only be used if supplied with optional security locking!
Advise
If the machine is supplied for a school, training or education centre the function of turning direction
can be blocked /disabled by a screw or splint.
Emergency-Off-Button/Mainswitch
The main switch on the headstock is also used as emergency-off-button
If the emergency-off-button was pressed down the button must be turned to activate electric power.
MOVABLE OPERATING BOX
The box is equipped with a “magnet” and can be placed at any position onto the lathe bed
Switches with following functions
Green button = “on”
Red button = “off”
Speed regulator or potentiometer = rotable knob :
Clockwise = increasing the rpm
Anti-clockwise = decreasing the rpm
Turning direction of spindle fwd/rev
Attention: the correct working direction for turning is lefthand i.e. anticlockwise !
SWIVELLING OF HEADSTOCK
the headstock can be swivelled in 6 different positions: 0/60/90/120/180/270°
switch machine off, never turn headstock if motor is switched on
loosen the headstock fixing lever on lefthand side of headstock
loosen headstock fixing pin on front , pull it out
rotate the headstock to one of the 6 possible positions:
take care of your fingers, do not squeeze them between lathe bed
push in the pin until it engages automatically into the given position
a
t least tighten the fixing pin and the headstock fixing lever again
