Steiner M1050r LRF, Instruction Manual

Page: 8 / 12

8
SET BUTTON
4
The range can be displayed either in meters or in yards, as
desired. After pressing the button for distance measuring
3
a ‘m’ for meter or ‘y’ for yards is displayed next to the target
marker.
To change the setting, use the SET button
4
: An extended
press of the button for over 3 seconds will cause the display to
start to fl ash and the setting to then change every time the SET
button is pressed.
All settings preset for the ‘m’ represent range displays in
meters; all settings preset for the ‘y’ represent range displays
in yards. The selection of setting ‘m’ (display in metres) or
‘y’ (display in yards) is preferable for the basic use. After 5
seconds without pressing the SET button the respective setting
is saved automatically.
SCAN MODE
The STEINER Military 10x50 Laser rangefi nder binocular can
also be used to measure in constant operation (scan mode).
The scan mode is particularly helpful for measuring small or
moving targets.
If the button for measuring distance
3
is pressed for longer
than approx. 3 seconds, the binocular switches to scan mode
and then takes measurements continuously. This can then be
identifi ed from the range display which emits new measuring
values approx. every 1.5 seconds.
Note:
Scan mode consumes more power than individual
metering due to the constant metering. Scan mode switches
off automatically after approx. 20 seconds in order to save the
battery in case the button is pressed accidentally.
DISTANCE MEASURING