5
TURF UNIT
CAB
INSTALLATION / REMOVAL
INSTRUCTIONS FOR MOUNTING ASSEMBLED CAB ON 220 TURF UNIT
NOTE: Detailed Cab Assembly Instructions are found in the assembly instructions found on Pages 7-16.
1.
Turf Unit must be equipped with a roll bar.
2.
Remove 3 roll bar mounting bolts on each side where the cab mounts.
3.
With the cab doors removed, position the assembled cab into position around the roll bar.
4.
Fasten the cab to the roll bar with the “U-type” clamps and 3/8 X 3 bolts. Install the front lower corners to
the front fenders and dash side panels with 5/16 X 1/2 flange bolts.
NOTE: The top bolt of the dash side panel uses existing bolt (230 only). Model 220 needs holes drilled in
the dash. See Page 9, Step 11.
5.
Replace roll bar mounting bolts removed in step 2.
6.
Install the cab doors and check for proper latch closure. Adjust latches as needed. See Page 13, Step
23 for adjustments.
7.
Connect wiring for the wiper motor.
INSTRUCTIONS FOR REMOVING ASSEMBLED CAB FROM 2 X 4 TURF UNIT
1.
Disconnect wiring to wiper motor.
2.
Remove the doors.
3.
Remove the bolts at the front fenders and dash side panels.
4.
Remove the 3 bolts that support the roll bar and cab on each side.
5.
Remove the “U—type” clamps which clamp the cab to the roll bar.
6.
Get an assistant to help and carefully lift the cab up and away from the roll bar.
7.
The roll bar may remain on the turf unit.
8.
Replace the bolts as needed with the cab removed.
