STEINEL Control Pro DT Quattro DCS, Manual

Page: 59 / 63

- 59 -
• Make settings.
➔
"6. Function / Setting"
• After installing the sensor starts
to flash once a second for aprox.
2 minutes. Follow the next steps
on the commissioning App of
the DCS.
Mounting procedure 2
• Connect to the bus powered
data line of the room controller.
(Fig. 4.1/5.4)
• Mount the power module to
a 4" Square box, 4" Octagon
box or Round 3.0 Mud-Ring.
(Fig. 5.3/5.4/5.4)
• Mount the sensor module to the
power module by carefuly opening
the locking tabs on the side of the
sensor module. (Fig. 5.4/5.5)
• Wait for the system to reboot.
• Make settings.
➔
"6. Function and Settings"
After installing and switching ON, the
sensor starts to flash once a second.
US Quattro DCS
10 s
US Oneway DCS 10 s
DT Quattro DCS 40 s
US Hallway DCS 10 s
6. Function / setting
The motion detection values and light
levels measured by the sensor can
be requested from the DCS controller
App.
LED function
Red LED:
– During installation and Data Line
addressing, LED flashes 1 x per
second.
The lead between the DCS and the
sensor must be no longer than:
– 984 ft (300 m) for 1,5 mm²
14 AWG
After the sensor is powered on it
flashes for 10 s.
Note on parallel connection:
– Tangential - motion perpendicular
to the sensor.
– Radial - motion either directly
toward or away from the sensor
– Presence - minor motion as
described by NEMA WD7 with
the additional requirement of both
radial and tangential detection
5. Mounting
• Check all components for
damage.
• Do not use the product if it is
damaged.
• Select an appropriate mounting
location, taking the reach
and motion detection into
consideration. (Fig. 3.3/3.4)
• Select the appropriate
orientation. (US Oneway DCS/
US Hallway DCS) (Fig. 5.1)
Mounting procedure 1
• Drill a hole in the ceiling of
min. Ø 2.67 in (68 mm)/max.
Ø 3.00 in (76 mm). (Fig. 5.2)
• Connect to the bus powered
data line of the room controller.
(Fig. 4.1/5.3)
• Mount directly to ceiling with quick
mount spring tabs. (Fig. 5.3)
• Insert the sensor into the load
module. (Fig. 5.3)
• Wait for the system to reboot.