STEINEL PROFESSIONAL DualTech COM1, Operating Instructions Manual

Page: 20 / 162

- 19 -
L
Disconnect the power supply
before attempting any work
on the sensor!
L
During installation, the elec-
trical wiring you are connect-
ing must be dead. Therefore,
switch off the power first and
use a voltage tester to make
sure the wiring is off circuit.
L
Installing the sensor involves
work on the mains power
supply. This work must there-
fore be carried out profes-
sionally in accordance with
the applicable national wir-
ing regulations and electrical
operating conditions
(VDE 0100).
L
Terminal B 1, B 2 is a switch-
ing contact for low-energy
circuits, not more than 1 A.
This must be protected a fuse
of the appropriate rating.
L
Only electronic ballasts with
a floating control signal may
be used at DIM 1-10 V control
output.
System Components
a
Load module
b
Sensor module
c
Sensor base
d
Dip switches
(1) Normal/test mode
(2) Semi-/fully automatic mode
(3) Button/switch
(4) ON / ON-OFF button
(5) DIM option
Constant lighting control
ON/OFF
(6)(7)(8)
Trigger mode
(DT Quattro only)
e Light-level setting
f
Time setting
Switching output 1
g
HVAC stay-ON time
Switching output 2
h
HVAC switch-ON delay
Switching output 2
i
Reach setting

10.
1
Kaiser hollow-wall box,
optional

10.
2
Clamping-type ceiling adapter,
optional
k
Surface-mounting adapter
IP 54, optional
l
Locking mechanism
m
Assembly/Installation
n
Parallel-connected
configurations
o
Stay-ON time
Orientation light
DIM option
Assembly/Installation
m
(see fig. on page 2)
The sensor is only intended for
concealed, indoor installation
in ceilings. A clamping-type
ceiling adapter or surface-
mounting adapter is not
included. Sensor and load module come
ready assembled and must be
plugged together after fitting
the load module and setting
the potentiometers/dip
switches. The sensor module
must now be locked in place
with the catch mechanism
l
,
using a screwdriver if necessary.
Accessories:
Kaiser hollow-wall box,
EAN no.: 4007841 000370
Clamping-type ceiling adapter,
EAN no.: 4007841 002855
Surface-mounting adapter,
EAN no.: 4007841 000363
Guard cage,
EAN no.: 4007841 003036
Service remote control,
EAN no.: 4007841 559410
User remote control,
EAN no.: 4007841 592806
Operating Instructions
GB
Dear Customer,
Congratulations on purchasing
your new STEINEL sensor and
thank you for the confidence
you have shown in us. You have
chosen a high-quality product
that has been manufactured,
tested and packed with the
greatest care. Please familiarise
yourself with these instructions
before attempting to install the
sensor because prolonged, relia-
ble and trouble-free operation
will only be ensured if it is fitted
and used properly.
We hope your new STEINEL sen-
sor will bring you lasting pleas-
ure.
Safety precautions
GB