AXR4 Getting Started
7
• To ensure proper heat dissipation of the product, when
installing it:
- Do not cover it with any cloth.
- Do not install it on a carpet or rug.
- Make sure the top surface faces up; do not install on its
sides or upside down.
- Do not use the product in a confined, poorly-ventilated
location.
Inadequate ventilation can result in overheating, possibly
causing damage to the product(s), or even fire.
• If the product is mounted in an EIA standard rack, carefully
read the section “Precautions for Rack Mounting” of the AXR4
Operation Manual. Inadequate ventilation can result in
overheating, possibly causing damage to the product(s),
malfunction, or even fire.
If this product is to be used in a small space other than an
EIA-standard rack, make sure that there is adequate space
around the product: at least 15cm above, 2cm at the sides
and 5cm behind.
• Do not place the product in a location where it may come into
contact with corrosive gases or salt air. Doing so may result in
malfunction.
• Before moving the product, remove all connected cables.
Maintenance
• Remove the power plug from the AC outlet when cleaning the
product.
Handling caution
• Do not rest your weight on the product or place heavy objects
on it.
Notice
To avoid the possibility of malfunction/damage to the product,
damage to data, or damage to other property, follow the notices
below.
Handling and maintenance
• Do not use the product in the vicinity of a TV, radio, or other
electric products. Otherwise, the product, TV, or radio may
generate noise.
• Do not expose the product to excessive dust or vibration, or
extreme cold or heat, in order to prevent the possibility of
panel disfiguration, unstable operation, or damage to the
internal components.
• Do not install in locations where temperature changes are
severe. Otherwise, condensation may form on the inside or
the surface of the product, causing it to break.
• If there is reason to believe that condensation might have
occurred, leave the product for several hours without turning
on the power until the condensation has completely dried out,
in order to prevent possible damage.
• Do not place vinyl, plastic or rubber objects on the product,
since this might cause alteration or discoloration of the panel.
• When cleaning the product, use a dry and soft cloth. Do not
use paint thinners, solvents, cleaning fluids, or chemical-
impregnated wiping cloths, since this might cause alteration
or discoloration.
• To avoid generating unwanted noise, make sure there is
adequate distance between the AC adaptor and the product.
Connectors
• When connecting D-sub cables, be sure to tighten the screws
on both sides of the connector securely. To disconnect the
cable, loosen the screws completely, then remove the cable
by holding the connector part. Do not remove the plug by
pulling the cable while the screws are still attached.
Otherwise, the connector may be damaged, leading to
malfunction.
PA_en_11 2/2
Summary of Contents for AXR4T
Page 15: ...AXR4 Getting Started 15 MEMO...
