Steinbach Schwimmbadreiniger, Original Owner'S Manual

Page: 53 / 404

Fault description Cause Remedy
The device cannot reach all
spots.
The control unit was wrongly
positioned.
Position the control unit so
that the device can easily
access all spots.
The water circulation of the
pool is switched on.
Switch off the filter system of
the pool.
The cable is too short. Let a sufficient length of cable
into the pool so that the device
can reach all spots in the pool.
Observe the minimum
distance of the control unit to
the pool.
The device does not
completely move up the wall.
The filter is clogged. Clean the filters.
Algae grows on the walls. Clean the pool walls.
The water temperature is too
high or too low.
Operate the device at water
operating temperature (see
section "Technical data").
The drive belt or the cleaning
rollers are worn.
Check the drive belt and the
cleaning roller for wear and
replace them if necessary.
The device is too light and
topples.
Switch off the device and let all
the air escape.
The pH value is not correct. Adjust the pH to the correct
value (see section "Technical
data").
The device has too little
buoyancy.
Attach additional buoyancy
aids (part of the package
content). See "Installing the
buoyancy aids".
The app does not show any
available devices.
Inactive services or missing
authorizations.
- Activate Bluetooth and
with Android also GPS.
- Allow the App to obtain
the device's location.
If the problem cannot be solved, contact the customer service listed on the last page.
53