Steinbach HJ1103, Original Owner'S Manual

Page: 26 / 185

11
2
4
12
3
4
1. Pull the two latches apart and lift off the top part
2
.
2. Take the filter unit
3
out of the bottom part
4
.
3. Thoroughly rinse the filter unit
3
with plain tap water.
4. Rinse the device after each use with plain tap water inside and out.
The device is clean.
Storage
1. Thoroughly clean the device (see section "Cleaning").
2. Let all parts dry completely.
3. Fully charge the device.
Recharging is required after at latest 3 months due to self-discharge.
4. Then store the device and its accessories in a dry and frost-free place (≥ +5 °C) without direct
sunlight.
Troubleshooting
Fault description Cause Remedy
The device cannot be switched on
and the status indicator is not lit. The rechargeable battery is dead. Charge the rechargeable battery.
The rechargeable battery is
defective. Contact customer service.
The charge control indicator is not
lit. The charger is defective. Contact customer service.
The rechargeable battery running
time is shorter than expected. The water temperature is too low. Only use the device under the
permissible operating conditions.
See section "Technical data".
The rechargeable battery was not
completely charged. Charge the rechargeable battery
completely.
The device does not work and the
status indicator blinks red. The device has a fault. Contact customer service.
The device cannot reach all spots. The nozzle setting is not suitable. Change the setting of the nozzles.
The water circulation of the pool is
switched on. Switch off the filter system of the
pool.
The device does not function. There are foreign objects in the
drive. Contact customer service.
26