5
Heatmaster
ss
G Series Furnace Operating Manual
Read and understand all precautions before operating
the furnace. This furnace needs a periodic inspection for
proper operation. It is against federal regulations to operate
this furnace in a manner inconsistent with operating
instructions in this manual. Save these instructions. Retain
this manual as long as you own your G Series outdoor
furnace. Carefully read and follow these directions.
DANGER
Do not start the fire with or burn garbage, gasoline, naphtha,
engine oil or other inappropriate materials. Only competent
persons with a sound understanding of this heating method
that are qualified and trained should operate this furnace.
Improper firing could result in personal injury and/or
damage to the unit and void warranty.
ATTENTION
•
USE APPROVED FUELS ONLY!
•
The person(s) operating this furnace must comply with all
applicable local and state laws or other requirements.
•
The person(s) operating this furnace is responsible to
run it in such a way so that it does not cause a public or
private nuisance. Consult with local authorities prior to
installation to adhere to local laws and ordinances.
•
DO NOT OVER FIRE THIS HEATER. Attempts to achieve
heat output rates that exceed the heater design
specifications can result in permanent damage to the
heater.
WARNING
•
All installations and operations of your furnace must
follow state, provincial, and local laws pertaining to
operations, wiring, plumbing and building codes.
•
All models operate at atmospheric pressure. DO NOT
obstruct, block or plug the overflow vent tube in any way,
which is located on top of the furnace.
•
When installing the furnace, the chimney should never be
connected to a chimney flue serving another appliance.
•
DO NOT operate furnace in event of power failure. Use
caution when opening the firebox and ash cleaning doors.
Push the by-pass handle towards the back of the furnace
and slowly crack the door open for at least 20 seconds
before fully opening the door.
•
DO NOT use chemicals or fluids to start the fire.
Risk of Fire:
•
DO NOT operate with fuel loading or ash removal doors
open.
•
DO NOT store fuel or other combustible material within
marked installation clearances.
•
Inspect and clean flues and chimney regularly.
•
This appliance should not be installed in a location
where a corrosive atmosphere, flammable gas or vapour,
combustible dust or combustible fibers may be present.
If flammables are present in the building, ensure ducts,
vents and doorways between the rooms are sealed so as
to not allow vapours or fibers to travel to the appliance.
CAUTION
•
DO NOT start or operate furnace without checking the
heating fluid.
•
The furnace must be filled until heating fluid comes out
the vent pipe on top of the furnace.
•
Check for buried cables and utility lines before digging the
trench to your furnace.
•
For safety and proper temperature control keep all doors
closed during operation.
•
Hot Surfaces: Keep children away. Do not touch during
operation.
ATTENTION: DO NOT CONNECT THIS UNIT TO A
CHIMNEY FLUE SERVING ANOTHER APPLIANCE.
SAFETY PRECAUTIONS
