SBM-500
SBM-
500 Operator’s Manual
22
3.8. Removing and installing the milling head
Unplug the machine from the power source. Then, lift the feed unit (
1
, Fig. 13) and
move the table back (
2
) to get access to the milling head. Use a 14 mm flat wrench to
prevent the rotation of the spindle (
3
). Then, use the 8 mm hex wrench to remove the
milling head (
4
).
To install, put the milling head on the spindle and prevent the rotation of the
spindle. Then, use the removed screw and washer to tighten the milling head.
Fig. 13.
Removing the milling head
3
4
1
2
