Rail Runner 2
Rail Runner 2
– Operator’s Manual
24
Parameter Value
Description
Method
of control
1
–10
New configuration.
Rotate
Copies the loaded configuration to the chosen num-
ber of the new configuration.
Press
Saves changes to the loaded configuration.
Press
To go back to the main screen, press and hold the two navigation buttons for
three seconds.
To control the torch through the carriage, set the arc ignition switch to ‘I’.
If the arc ignition switch is set to ‘I’, the torch starts welding prompt-
ly after you select a travel direction.
Use the direction switch to select a direction of travel. Then, the travel starts with
the set parameters. Then, the status changes from
to
. You can
adjust the parameters from the main screen at any time with the knobs. You can
adjust the parameters from the setup screens only when the carriage is stopped.
To stop the travel, set the direction switch to ‘O’.
After the work is finished, use the power switch to turn off the carriage. Then,
unplug the carriage from the power source.
