ARC Runner
ARC Runner Operator’s Manual
8
2. SAFETY PRECAUTIONS
1. Before starting
, read this Operator’s Manual and complete proper occupational
safety and health training.
2. Use the
carriage
only in applications specified in this Operator’s Manual.
3. The
carriage
must
be
complete
and
all parts must be genuine and fully functional.
4. The
specifications of the power source must
conform
to
those
specified
on
the
rating
plate.
5. Connect the carriage into a properly grounded power source.
6. Never carry the carriage by the cords or arc ignition cable. Never pull them
because this may damage them and result in electric shock.
7. Untrained bystanders must not be present near the carriage.
8. Before
starting,
ensure the correct condition
of
the
carriage,
power
source,
cords,
arc ignition cable, plugs, control panel, and wheels.
9. Keep the carriage dry, and never expose it to rain, snow, or frost.
10. Keep the work area well lit, clean, and free of obstacles.
11. Never use near flammable liquids or gases, or in explosive environments.
12. Make sure that the rubber of the wheels is clean and not damaged.
13. Never remove the cover of the wheels.
14. Remove objects attracted to the chassis by the magnet.
15. Transport and position the carriage by using the carrying handle and only when
the magnet ON/OFF lever is set to
‘O’.
16. Position
the
carriage
on
the
ferromagnetic
workpiece
so that the wheels are in
contact with the surface and no contact is between the surface and chassis.
17. Do not stay below the carriage placed at heights.
18. Plug the cords and arc ignition cable only when the power switch is set to
‘O’.
19. Keep the sockets clean. Do not use compressed air for cleaning.
20. Install only MIG/MAG torches whose handle diameter is the same as the diameter
of the torch holder in use.
21. Do not position the torch more than
80 mm (3.15’’) outward from the left or right
side of the carriage.
22. Keep the torch cables from coming in contact with the surface. They must be
suspended to reduce the load of the carriage. Use only cables whose weight is
not more than 12 kg (27 lbs) for horizontal work and 8 kg (18 lbs) for vertical work.
Summary of Contents for ARC Runner
