ST1008 Mini Wood Lathe
-27-
MAINTENANCE
Changing Belt
Lubrication
Lubricate the locations shown in Figure 39 with
light machine oil.
Figure 39. Lubrication locations.
General
Cleaning the Model ST1008 is relatively easy. Vacuum
excess wood chips and sawdust, and wipe off the
remaining dust with a dry cloth. If any resin has built
up, use a resin dissolving cleaner to remove it.
Cleaning
Regular periodic maintenance on your STEELEX™
Model ST1008 will ensure its optimum performance.
Make a habit of inspecting your machine each time
you use it.
Check for the following conditions and repair or
replace when necessary:
Daily Check:
•
Loose mounting bolts.
•
Worn or damaged wires.
•
Worn switch.
•
Any other unsafe condition.
Monthly Check:
•
Belt tension, damage, or wear.
•
Clean/vacuum dust buildup off of motor.
Unpainted Cast Iron
Protect the unpainted cast iron surfaces on the lathe
by wiping them clean after every use—this ensures
moisture from wood dust does not remain on bare
metal surfaces.
Keep the bed rust-free with regular applications of
quality metal protectant products.
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may result
in serious personal injury.
To change the belt:
1. Perform Steps 1-2 in the Changing Speeds pro-
cedure on Page 18.
2. Roll the belt off of the pulleys and slide it under
the spindle cover plates.
3. Place new belt on pulleys, then repeat steps
Steps 1-2 in reverse to reinstall the belt.
