Page 3 of 5
Rev B
1.
Position chair as shown. Remove all casters
from base as noted above.
2.
Remove base by hitting bottom of
cylinder with a hammer while pulling forward on
chair base.
Note:
Be careful not to hit the retaining clip or
cylinder rod in center of cylinder, as this may
cause cylinder to break apart.
Hit bottom of base legs with a plastic mallet to seat
base to the cylinder.
4.
Insert casters into base and tap them in
with a plastic mallet.
5.
Flip chair upright and sit in seat several
times to make sure base is properly seated on
cylinder.
1.
Position chair on its side on a clean soft surface.
2.
To remove casters: Pull outwards on casters
while tapping base with a plastic mallet.
3.
Insert new casters into base and
tap them in with a plastic mallet.
Caster Replacement
Base Replacement
CASTER
NOTE:
DO NOT hit the inner
cylinder rod with the hammer.
Hit the outer rim of the cylinder.
BASE
IF REMOVING
BASE
2
2
1
®
