Assembly Directions
REV A
Y9501911
Page
10 of 11
Steelcase
FLUSH
3/4” SCREWS
19.
Screw the Back Unit’s levelers all the way in, then slide into position with bridge and
Partition Wall. The Back Unit’s inside edge should be flush with inner edge of the
Partition Wall. Once aligned, install 3/4” screws through support leg angle bracket
and into the worksurface of the Back Unit. Level Back Unit as necessary.
ANGLE BRACKET
INSTALLATION OF
BACK UNIT
18.
Bridge installation is similar to a Return, except that a Back Unit must
accompany the bridge . Support Leg attaching to Corner Unit must
be installed as shown in Fig. B, Step 16. Support Leg attaching to
Back Unit must be installed as shown in Fig. C above.
Fig. C
(top view)
SUPPORT LEG
WITH ANGLE BRACKETS
WORKSURFACE
FLUSH
INSTALLATION OF
BRIDGE
