Product description
_______________________________________________________________
157238
5
3
Product description
Dimensions and weight specifications of your product
can be found on the delivery note.
3.1
Technical data
Solo Sit-to-Stand Desk
Dimensions and weight
See delivery note
Temperature range at the
setup location
+5°C to +35°C
Relative humidity
5% to 80% (non-condensing)
Input voltage range
220 to 240 V ˜
Frequency range
50 to 60 Hz
Maximum load capacity
75 kg
Maximum “ON” duration
2 min. ON/18 min. OFF
Input current
2.5 A
Maximum adjustment range:
Double telescope (Lift 2)
650 mm to 1250 mm
Noise emission
<60 dB (A)
Max. power consumption
during lifting
240 W
Power consumption in
standby mode
≤ 0.2 W
Memory control panel
Standard
Type plates are located on the power lift housing, on
the columns, and under the desktop near the control
panel.
Type plate: symbols
–
explanation
Double insulation
. Double insulated
cables minimise the risk of electrical
shock.
For indoor use
. Indicates that
placing the product outdoors is not
allowed.
CE marking.
Used to symbolise the
conformity of the product with the
applicable requirements that the
European Community places on the
manufacturer.
Recycling symbol.
Used to indicate
conformity with the regulations for
Waste Electric and Electronic
Equipment (WEEE) and the Electrical
and Electronic Equipment Act
(ElektroG). Electrical and electronic
products must be disposed of
separately from household waste at
the end of their service life.
The CE marking is located on the underside of the
desktop and can be viewed at any time.
3.2
Components
The
Solo Sit-to-Stand Desk
essentially consists of
the following components (the variant descriptions
can be found in the respective chapters):
■
Desktop
■
Horizontal structural profile section (bolted to the
desktop)
■
Software and hardware-supported stopping
device with a sensor for system protection
■
Columns with bolted steel pipe runner (88.5 x 48
x 1.5 mm), including adjustment screw for
compensating floor unevenness, and a cable duct
■
Plastic cap, top left/right
■
Desktop support, top left/right
■
Electrical height adjustment:
–
Lift 2: Electric motor (650 to 1250 mm), in
column, including software-supported
stopping device and sensor
–
Power lift for lifting height adjustment
–
Standard: Memory control panel with display
for height indication; programming function
for four desk heights
3.3
Factory setting on delivery
■
Lift 2 variant: 690 mm
You can change these settings according
to your needs. The corresponding
descriptions can be found under
5
Operating and adjusting
.
