Errors and malfunctions
_______________________________________________________________
14
157238
Signal/Code
Message
Required measure(s)
C2
Overcurrent with motor
Release all buttons and wait 5 seconds.
Then try again.
C11
Speed fails to be reached
Release all buttons and wait 5 seconds.
Then try again.
C13
DC undervoltage
Release all buttons and wait 5 seconds.
Then try again.
C17
Error with pairing
Disconnect the power supply from the
mains connection.
Then disconnect the system from the
power supply. Re-connect the system
and use it as usual.
If this is not possible, perform a reset
to the factory settings.
C19
Too many or too few drive units are
connected
Connect the correct number of drive
units (as specified under Setup).
C22
Overload of power supply
Release all buttons and wait 5 seconds.
Then try again.
