Page 2 of 4
003876D Rev T
®
DFPADUALCS
FYI Dual Flat Panel Monitor
Arm with c:scape Bracket
1b
2
CLAMPING
BRACKET
BRACE
BASE
BRACKET
1c
1a
FOR DUAL MONITOR ASSEMBLY ONLY
- Guide
brace into place, beneath worksurface. Install two
(2) but do not tighten yet.
T-NUT
FLAT SIDE TO
FACE BRACKET
RAIL
SCREW
Side View
4
3
5
6
7
7
Attach FYI arm to receiver with screw/washers
(included with FYI arm).
Attach FYI arm/receiver assembly to base
bracket with included hardware (qty 2).
Tighten screws from step 1.
Max. Torque 40 in-lbs (4.5 Nm)
Tighten screws from step 2.
Install plastic cover by sliding it over the top
of the base bracket.
PLASTIC COVER
BASE BRACKET
3
WASHER
LOCK WASHER
RECEIVER
FYI ARM
CAP SCREW
4
FYI ARM/RECEIVER
ASSEMBLY
4
FYI ARM/RECEIVER
ASSEMBLY
DFPASINGLECS
FYI Single Flat Panel Monitor
Arm with c:scape Bracket
1
2
Mount screws and t-nuts in the correct orientation
as shown (1a). Slide clamping bracket into bottom
of base bracket (note tab direction per side view
(1b) and lower onto rail at rear of c:scape desk (1c).
Align two (2) t-nuts with rail slot to aid installation.
Do not tighten screws yet.
FOR SINGLE MONITOR ASSEMBLY ONLY
-
Install two (2) screws but do not tighten yet.
Note:
Install (2) screws, but
omit the
brace
, when attaching to the
Campfire Big Table
with center
rail and trough.
Single
Dual
)
45 - 50 in-lbs
(5.1 - 5.7 Nm)