Page 3 of 5
939568006 Rev B
Attach Legs to Cabinet
3.
Attach front legs using (7) #10 x 1.075" screws,
each leg in predrilled holes.
NOTE: In a back-to-back condition with another storage
unit, to minimize the gap between legs: DO NOT use
predrilled holes to locate legs. Install rear legs first, by
aligning them flush to the rear of the unit and inset .062"
(1/16") from the side of the unit. Then install reveal and
use it to locate front legs.
4.
Attach two reveals using 8-32 x .375" tri-lobe
screws and washers, making sure its flush to front
legs.
5.
Flush rear legs to reveals and attach
using the #8 x .375" screws.
6.
Attach rear legs to case using the predrilled
holes and (7) #10 x 1.075" screws per leg.
FRONT LEGS
REAR LEGS
6
5
Tip: make sure that
the torque control drill
is set properly to prevent
stripping of screws.
3
4
Position reveal
flush with leg.
