Page 3 of 8
939500519 Rev B
®
Mounting Worksurfaces
1.
Mark height of worksurfaces to 27-1/2". Attach
the support brackets to the vertical junctions.
Pilot holes are provided.
2.
Lay worksurfaces on supports for the entire
workstation cluster, loosely securing each surface
to supports, and adjust worksurfaces for optimal
appearance. Secure screws starting with corner
workstation.
TIP: Scallop covers must be handled
with care to avoid damage. Using the
scallops as a handhold is not
recommended. Replacement scallop
covers are available in 10-packs by
ordering service pack 891503042SR.
A hot glue gun is recommended for
repairing or replacing scallops.
Wi
ng
Prim
ary
Attaching Adjoining Worksurfaces
with Support Plates
Place support plates as shown. Secure a screw in
all available holes.
27-1/2"
