LINE
1
LINE
1
Assembly Directions
93-9501147 REV -
Page
2 of 4
Panel Base Receptacle Installation
Remove trim by pushing down on steel tabs at the bottom extreme
ends (in area of glides) and lifting straight up and out.
1.
APPLY PRESSURE TO STEEL TABS
BASE TRIM
Position duplex receptacle to panel powerway assembly.
Secure receptacle with (2) screws
2.
STRUCTURAL PANEL
POWERWAY
SCREWS
DUPLEX
RECEPTACLE
Remove access cover from base trim.
3.
ACCESS
COVER
BASE
TRIM
Replace trim by reversing removal procedure.
NOTE: If receptacle and base trim do not align, the
powerway may be adjusted by loosening the (2)
powerway mounting screws and sliding the power-
way to either end. Re-tighten screws and replace
base trim.
4.
DUPLEX
RECEPTACLE
BASE
TRIM
