DO NOT
touch the saw blade when cutting.
During saw operation, wear safety glasses, but
DO NOT
wear gloves.
Cut only
ONE
workpiece at a time.
ALWAYS
hold the workpiece down on the table.
DO NOT
jam any workpieces.
DO NOT
try to slow the saw blade band down or stop it by pushing the workpiece against the saw blade from the side.
When straight cutting against the fence
USE
a push stick.
USE
work support when cutting long stock, this would otherwise fall off the table on completion of cut.
USE
dust collector.
When cutting round stock,
FIRMLY
secure it.
Before starting work,
CHECK
the saw blade’s upper and lower blade guard are in proper working order.
REPLACE
damaged parts immediately.
Assume correct work position (the bandsaw blade’s teeth must point towards the user).
Take care to avoid a risk of a kickback.
11
To reduce the risk of personal injury, the following safety recommendations should be observed when operating the saw.
OPERATIONS
WARNING:
Switch action.
To start the tool, turn ON the main switch.
To stop the tool, turn OFF the main switch.
Using rip fence.
The rip fence can be used on both sides of the blade. When the rip fence is moved from one side of the saw blade to the other, the fence needs to reverse.
LED work light.
The LED work light is built onto the long flexible goose neck giving it
the ability to illuminate the work surface on both sides of the blade.
Push the upper position (I) of the LED light switch for turning ON the
light and the lower position (O) for OFF.
Reversing the fence.
Loosen and remove the two knobs (G).
Take off the fence with bolts from the fence support.
Assemble the fence with bolts to the other side of the fence support.
Replace the two knobs (G).
LED light switch
Main switch
G