Steca StecaGrid Control I1, Installation And Operating Instructions Manual

Page: 46 / 92

46 738.977 | 1149
EN
8.3 Remote display with 2 or 3 monitor-
ing units
1. Start initial commissioning of one of the systems, hereaf-
ter known as System A . Perform only the steps 1. to 3. in
Remote display with 1 monitoring unit p. 46.
2. Replace the monitoring unit display of the next system
(
System B)
with the display from
System A
.
3. Perform initial commissioning of System B , as described
in step 1 for System A .
4. Replace the monitoring unit display of the next system
( System C) with the display from System B .
5. Perform initial commissioning of System C , as described
in step 1 for System A .
6. Perform steps 4. to 7. in Remote display with 1 monitor-
ing unit . The following applies:
–
After the display test, the number of HF connections
that have been established is displayed:
rF 2
or
rF 3
.
The system is now ready for operation.
–
The specified output and power values are now the
respective summed values of the three individual
systems.
–
System messages are displayed alternately:
• Error message:
Err
and the error number
• System letter A, B or C (
A
,
b
,
C
), inverter number
and error code
Example (see adjacent Fig.):
Err 1 / A02.40
Err 2
/
b01.44
More information on this is provided in Display mes-
sages .
OFF STANDBY ACTIVE
W/ m 2
kWh
C
IRRAD POWER TEMP ENERGY /D /Y /M /W
OFF STANDBY ACTIVE
W/ m
2
kWh
C
IRRAD POWER TEMP ENERGY /D /Y /M /W
OFF STANDBY ACTIVE
W/ m
2
kWh
C
IRRAD POWER TEMP ENERGY /D /Y /M /W
OFF STANDBY ACTIVE
W/ m 2
kWh
C
IRRAD POWER TEMP ENERGY /D /Y /M /W
OFF STANDBY ACTIVE
W/ m
2
kWh
C
IRRAD POWER TEMP ENERGY /D /Y /M /W
OFF STANDBY ACTIVE
W/ m
2
kWh
C
IRRAD POWER TEMP ENERGY /D /Y /M /W