8 | ENGLISH
Assembling Your
Canister Steam Cleaner
STEAM CLEANING ACCESSORIES
WARNING: Do not try to connect accessories while unit is emitting steam.
STEAM JET NOZZLE / SQUEEGEE / TRIANGLE BRUSH
1.
Select one of the three accessories (Steam Jet Nozzle, Squeegee or Triangle Brush – Steam
Jet Nozzle shown as example), and align rear end of accessory with Main Nozzle.
Rectangular hole in accessory should align with gray lock/release button on Main Nozzle.
2.
Press down on gray lock/release button (FIGURE 4-A). While continuing to hold button down,
slide accessory onto Main Nozzle (FIGURE 4-B). Push accessory over button, and continue
pushing until button snaps through rectangular hole.
NOTE: The Steam Jet Nozzle, Squeegee and Triangle Brush can be connected to the end
of an Extension Wand for reaching high or difficult spots. Connect the Extension Wand
(or Wands) as outlined on Page 6, then connect your desired accessory to the Wand in
the same way as you would normally connect it to the Main Nozzle.
UTILITY BRUSHES
NOTE: Utility Brushes connect to the Steam Jet Nozzle, not the Main Nozzle.
1.
Align guide tab on inside of Utility Brush (FIGURE 5-A) with groove on bottom of Steam Jet
Nozzle tip (FIGURE 5-B).
2.
Firmly press Utility Brush onto tip of Steam Jet Nozzle. Press it on as far as possible to
prevent steam leakage (FIGURE 5-C).
3.
To remove Utility Brush, simply grip it firmly and pull it off of Steam Jet Nozzle.
FIGURE 5
FIGURE 4
A
B
A
B
