89
www.steamax.com
STEAMAX PROCOLOR – ERROR MESSAGES & PROTECTIONS
The device could not detect a atomizer head. Please install a atomizer head or check that it is properly connected.
A (new) atomizer head was detected in temperature mode (TC).
Resistance too low (“OHMS TOO LOW”)
The resistance of the atomizer head is lower than 0.1 ohm in Watt Mode (VW) or lower than 0.06 ohm in Temperature Mode
(TC). Use a atomizer head with a resistance above these limits.
Resistance too high (“OHMS TOO HIGH”)
The resistance of the atomizer head is greater than 3.0 ohm. Use a atomizer head with a resistance below this limit.
Short Circuit Protection (“ATOMIZER SHORTED”)
A short circuit has been detected. Please replace the atomizer head with a new one.
Temperature Protection (“TEMPERATURE PROTECTED”)
Automatic temperature protection in Temperature Mode (TC).
Dry Atomizer Head (“DRY COIL NO LIQUID”)
The atomizer head was fired while dry, i.e. insufficiently moistened with liquid. Fill up the liquid and give the head plenty
of time to fill up with liquid.
