10
Place the cup in the center of the circle on the tray.
It is very important to use cups that are not larger than 4.25in/110mm (outer diameter)
and that the handles of the cup are no higher than the lip of the cup, as shown in below.
7.1 Placement and Orientation of the Coffee Cup
1.
Not following these instructions could cause damage or injury.
2.
The cup may contain a hot drink, therefore pay close attention to the start of the printing
and collect the cup immediately after the printing is completed.
7.2.1 Fast Print
7.2 Choosing a Design and Printing
This will immediately initiate the printing process.
Figure 7.1: Placement and Orientation of Coffee Cup
Figure 7.2: Foam Height Illustrations
The following illustrations show how the foam itself should be poured into the coffee cup
7.1.2
Foam Height Guidelines
foam
espresso
perfect
foam height!
foam
too high
foam
too low
1.
Choose the desired category from the bottom menu.
The Ripples that belong to that category will now be
displayed.
2.
Choose a Ripple by swiping it left or right then tap
on it in order to print it.
Figure 7.3: Main Menu
Summary of Contents for The Ripple Maker
Page 1: ......
