Continued on Next Page
SB-SC-TCG2/10W3v3 INSTR_SKU# 011323
s t e P 7
Remove the trunk floor.
s t e P 6
Using a 1/2” drill bit, enlarge the hole in the fender well.
Before drilling, always make sure that you are not
going to be drilling into any gas lines, brake lines,
tires, transmission lines, electrical wiring, exhaust
systems or anything else that might cause a
reduction in your weekly pay.
always wear eye protection when drilling!
s t e P 5
Using a 1” hole saw, enlarge the hole drilled in the side panel
in
step 4
. Do not enlarge the hole in the fender well.
s t e P 4
Remove the Stealthbox® from the vehicle. Using a 1/4” drill
bit, drill through the side panel on the mark made in
step 3
,
and continue to drill through the fender well.
Before drilling, always make sure that you are not
going to be drilling into any gas lines, brake lines,
tires, transmission lines, electrical wiring, exhaust
systems or anything else that might cause a
reduction in your weekly pay.
always wear eye protection when drilling!
Page 2 • JL Audio, Inc 2011
S T E P 9
Remove the sill panel by pulling up on the panel to release
the clips.
S T E P 1 1
With the side panel pulled away from the quarter panel,
drill a hole in the panel as shown, and route speaker cable
through the hole and out from under the panel.
Reinstall the side panel, and route the speaker cable as
necessary. Reinstall the sill panel, storage tray, jack, and trunk
floor.
S T E P 1 0
Remove the three 10mm screws that secure the side panel
to the vehicle, unclip the panel, and pull the panel out, as
shown. It is not necessary to completely remove the panel
from the vehicle.
S T E P 8
Remove the jack from the storage tray. Remove the two
10mm screws that secure the tray to the vehicle, and remove
the tray.
