Stealth 0200481, Operator'S Manual

Page: 7 / 15

7
ASSEMBLY INSTRUCTIONS
1
Fig A
12 / 31 cm
2
3
Unpack the air compressor unit. Inspect the unit for damaged. If the unit has been damaged, contact the
retailer immediately.
Check the air compressor’s identification label to ensure that you have purchased the intended model and
that it has the required pressure rating for its intended use.
Air compressor
Owner's manual
The carton should contain:
Positioning of the air compressor
Connect air hose to compressor
Note:
Position the air compressor (1) near an electrical outlet (2) (Fig A).
The compressor must be at least 12”(31cm) from any wall (3) or
obstruction, in a clean, well-ventilated area to ensure sufficient air flow
and cooling (Fig A).
Place the air compressor on the floor or a hard,level surface.The air
compressor must be level to ensure proper drainage of the moisture in the
tank.
Connect the air hose (1) to the compressor’s quick coupler (2) with the
quick conncetor (3) (Fig B).
Air hose and quick connector are not provided, need to be purchased
sepa rately. Apply plumber's tape on all the threads to prevent air
leakage.
1.
2.
3.
1.
High pressure air could result in death or serious injury. Never operate above maximum
operating pressure of the spray gun or tool.
Hot compressor surfaces could result in serious injury. Allow compressor to cool before
touching.
WARNING
WARNING
Notice
If the pump has been transported or turned upside down (even partially), allow the pump to sit
in a normal, upright position for approximately 10 minutes before starting.
Risk of serious eye injury from moisture and debris. Always wear ANSI Z87.1 safety
goggles when opening drain valve.
High pressure air could result in death or serious injury. Shut off unit, unplug and
release air pressure prior to servicing.
High pressure air containing water condensation could result in minor or moderate
injury. Do not spray at any person.
WARNING
WARNING
CAUTION
•
•
•
•
Fig B
1
3
2