6
Installation Instructions
Mounting the i2i to Hardware
Link Hardware
To mount the
i2i
to the headrest hardware:
1.
Place the 17mm ball of the
mounting hardware into the
mounting socket in the rear
of the
i2i.
2.
Place the split ring over the
shaft behind the ball with the
split section facing down and
insert the four socket head
screws (B) through the ring
and into the threaded holes in
the rear of the
i2i
mounting
point.
3.
Tighten screws evenly with a
hex key, making sure to keep
the split ring parallel with the
mounting socket plate on the
i2i
. Do not overtighten.
There are three points of angle adjustment on
the link hardware. To adjust angles (C), lightly
loosen the flat head screws, set desired angles,
and tighten screws.
NOTICE
For full instructions on installation of the mounting
hardware to the chair, please consult the manual
included with the mounting hardware.
C
