Page 12 of 13
30.
Reattach and secure the
fascia, taillights, and other
vehicle components in reverse
order. Refer to Steps 1
-
14.
NOTICE: Remember to plug in the
(7) PDC sensor plugs in Step 14
before reinstalling the fascia.
NOTE:
Replace plastic rivets in the
wheel well with supplied plastic
rivets, see Step 7.
REINSTALL VEHICLE COMPONENTS
INSTALL WIRING KIT
CONTINUED
27.
Determine the amount of power wire needed to reach the control module at the rear of the
vehicle. Trim the control module power wire to remove excess length. Use the included blue
butt connector to crimp the power wire leading from the battery to the control module
power wire. Reinstall the 20 Amp fuse in the harness fuse holder located near the battery.
NOTICE (OPTIONAL): The butt splice connector is a heat shrink connector. Apply heat to
waterproof the connector after crimping.
28.
Test the 4
-
way plug using a multimeter or connect the plug to a trailer and verify that the
lights and brakes work correctly.
29.
Secure all wires and wiring components. Use the remaining cable ties to secure wiring so
that it is not loose and will not interfere with replacement of the fascia. Wiring should not be
visible once the vehicle is reassembled. Secure the gravel guard.
