Page 10 of 13
23.
Route the right turn signal
wire (green) to the passenger
side of vehicle. Remove the
tape from the taillight wiring
harness to expose wires. Use
clamp
-
on connector to
connect to indicated wire. (As
shown in reference table
below).
INSTALL WIRING KIT
CONTINUED
22.
The wires on the input side of
the module need to be
attached to the vehicle wiring.
Route the left turn signal wire
(yellow), marker light wire
(brown) and brake wire (red)
to the driver side of vehicle.
Remove the tape from the
taillight wiring harness to
expose wires. Use clamp
-
on
connectors to connect to
indicated wires. (As shown in
reference table below).
NOTE:
Vehicles may have different
wire colors than those shown. Verify
circuits (wire colors) with
multimeter.
CLAMP
-
ON CONNECTOR COLOR REFERENCE TABLE
SIGNAL INPUT WIRES
POWER & GROUND WIRES
FUNCTION
HARNESS
VEHICLE
LEFT TURN
YELLOW
BLACK/WHITE
12V+ (POWER)
BLACK
BATTERY (+)
RIGHT TURN
GREEN
BLUE/GRAY
GROUND
WHITE
GROUND STUD
MARKER
BROWN
GRAY/PURPLE
BRAKE
RED
BLACK/PURPLE
