Stealth Cam STC-U840IRS1, Instruction Manual

Page: 28 / 42

WWW.STEALTHCAM.COM
Toll Free 877-269-8490
28
Ø
Press the [UP] button TWO times to toggle to Video mode.
Ø
Press the [OK] button TWO times.
Ø
Press the [MENU] button once to exit.
•
30 seconds after you’ve made your adjustments, the camera’s green LED
light will begin blinking and enter count down mode. This is your
indication to leave the coverage area within one minute.
•
After one minute, the camera will enter either Burst mode or Video mode
based on your program setting. The camera will then time out between
05-­‐59 seconds or 1-­‐59 minutes, depending on your program setting.
NOTE: The time between motion detection and the camera taking
the pictures may vary due to lighting conditions, program settings,
and battery power level. The IR Emitter will only activate in low light
conditions.
USING THE CAMERA IN TIME LAPSE MODE
•
Mount the camera to the tree or other sturdy object using either a tree
screw (optional accessory) or supplied mounting strap.
•
Open the front housing and move the switch to the Manual mode.
•
Make sure your camera is in Time Lapse ( tLM) mode and not PIR mode. If
your not sure, please follow the “ Setting the Camera’s Operation Mode”
above to set the camera into tLM mode.
•
The camera’s green LED light will begin blinking and enter count down
mode. This is your indication to leave the coverage area within one
minute. After one minute, the camera will enter Time Lapse mode.