stayer SC250IW, Operating Instructions Manual, Page: 11 / 16

ENGLISH
11
11
11. Limits regarding the workpiece size
Limits as included in the present manual. Pag. 4.
12. General instructions for use
Warning!
1. Do NOT use the machine if it is in a bad condition, or
lacks parts including the prescribed upper guards (the
illustrations of the present manual may be used as an
orientative guide). Unplug it, remove it from the working
area and immediately send it to an authorized technical
service.
2. Know and comply with all safety measures before you
start the machine.
- Obligatory used of aspiration particle system when cut-
ting the wood.
Starting and stopping the machine
Warning!
1. Always avoid the engine interlocking.
2. Never leave the tool switched on unatended.
3. Never start the machine with the disc blocked, always
wait for the disc to reach it’s maximum speed before ma-
king any cuts.
4. Before stopping the tool the disc must be free of obsta-
cles and running freely.
Starting with the manual switch on the lower table
1. Push the rectangular power switch on the handle to ac-
tuate the motor.
Stopping the machine on the lower table
1. Stop pushing switch
Starting with the manual switch on the upper table
1. Push the green power switch
Stopping the machine on the upper table
1. Push the red switch
Cutting operation
Warning!
1. Respect the limits regarding the size and material of the
workpiece.
2. Use clamps to fasten the workpiece whenever possible.
3. For cutting big pieces always use the supports 7 .
4. For maximum tilted cuts, displace the moving stops 14 .
Cut on the lower table
Warning!
Rise the upper table’s height to cut on the lower table.
Work on 11 to rise it.
1. Adjust the desired angle with 1 and 10 .
2. Start the machine as explained previously and wait un-
till the disc reaches its maximum speed.
3. Proceed to cut moving the head advancing slowly.
Cut on the upper table
Warning!
1. The lower disc ward must be placed.
2. Start the machine as explained previously and wait un-
till the disc reaches its maximum speed.
13. Extraction of dust
The machine comes prepared for the vacuuming of parti-
cles generated in the cutting with an outlet in the back part
of the head.
The supplied bag can be used or coupled to a vacuum
with the supplied adaptor.
14. Regular Cleaning, maintenance and
greasing
14.1 Maintenance and cleaning
WARNING!
Take off the plug before performing any adjustment or
maintenance comeback.
Cleaning
Clean the machine starting with a brush or with a flat brush
so as to remove sawdust and with a soft cloth. If compres-
sed air is available, complete cleaning by blowing with the
compressed air pistol.
Maintenance
After each 2,000 hours of use or each two years the elec-
trical tool must be sent to the official technical service for
maintenance and complete revision.
Before each use, check nuts and joints to detect any vi-
bration issues and use. If there are gaps take the machine
to service.
Except squeeze and brush change, the machine does not
require any special maintenance by the user. Keep the
machine clean and use it correctly. Regularly have the
correctness of the adjustments checked by a sufficiently
trained user. In the case of any failure, contact our tech-
nical service.
Greasing
This machine does not require any specific greasing by
the user. Specific greasing of the electrical tool will be ca -
rried out on the occasion of the regular maintenance revi-
sions at the official technical service.
If despite the careful process of manufacturing and con-
trol, the electric tool breaks down, the repair should be
assigned to an authorized service technician for STAYER
electric tools.
For any consultation or request for replacement parts it is
essential that you indicate the article number that appears
on the plate of characteristics of the electric tool.