14
15
EN
EN
Insert the carbon rod through one of the wings, and then put the other end of carbon rod through
the fuselage. Put the servo wire & light wire and the flap pushrod through the fuselage into the
canopy.
Remove the seat in the cockpit and fix the battery with velcro tape. The movement of the CG should
not exced ±5mm and should be araound 52 mm.
07
08
17
18
Insert the carbon rod through the other wing. And also put the sero wire & light wire and falp
pushrod through the fuselage into the canopy. Fit the wings and the fuselage in place, then lock
09
10
Guide the flap pushrod into the screw-lock connector on the flap servo arm. Take the aileron servo
wire and connect to the servo extension leads. Take the wing tip light wires and connect to the light
unit. Ensure the polarity should be contacted correctly.
11
12
WING INSTALLATION
INSERT BATTERY
ELECTRONICAL SET UP
PROPELLER INSTALLATION
Install the propeller adapter with propeller over the motor shaft. Put the propeller washer on the
adapter shaft. Take the propeller nut and screw it on the adapter shaft. Tighten the nut with a hex
wrench.
13
14
15
16
Fix the spinner with the screw M2.5X14mm as shown.
