Status RH1800, Original Instructions Manual

Page: 8 / 48

8
OPERATION
EN
Vacuuming
• The inside diameter of the vacuum nozzle (13) is 40 mm. Insert an appropriatesized
tube into the vacuum nozzle.
• Connect your router with the vacuum nozzle to a household vacuum cleaner or to a
dust-extracting apparatus.
• Through this, you attain an optimal vacuuming on your work piece. The advantage: you
improve your machine as well as your own health. In addition, your work space stays
cleaner and safer.
• While working, existing dust can be dangerous ( Safety advice). The vacuum cleaner
used for the vacuuming must be intended for the material being worked on.
Remember that health-hazardous materials, such as asbestos, may not be used.
• In the industrial use of the machine, special regulations apply for vacuuming
mechanisms. Check the requirements with your professional association if necessary.
Mould cutter selection
• In this router, the mould cutter can be replaced by the following mould cutters: 6 mm,
8 mm,12 mm
• Most mould cutters can be found in these sizes. You can also use mould cutters out of
the following material, among other things:
HSS: Softwoods designated for working
TCT: Hardwoods, flake board, plastic, and aluminumdesignated for working
• Choose the appropriate mould cutter for your work. The following table shows which
mould cutter can be used for which type of work.
OPERATION
1 Slit cutter 6
Round
cutter
2 Screwc utter 7
Screw
cutter
3
Vs crew
cutter
8
Vs crew
cutter
4
Cone/
trapeze
cutter
9
Screw
cutter