Status RH1800, Original Instructions Manual

Page: 11 / 48

11
EN
• Loosen the set screw (8) of the depth measuring stick.
• Loosen the height adjuster (12) and press the drilling tool with the handle (2) far under,
so that it touches the work piece.
• Secure this adjustment by tightening the height adjuster.
• Make sure that the depth measuring stick (9) with the metal point (b1) is sitting on the
depth stopper.
• Now the starting position can be read from the read-o point on the depth measuring
scale (a1).
• The depthmeasuring stick (9) canbefinely adjusted, so that the desiredcentimeter
number is displayed on the scale. Turn the fine adjuster of the depth measuring stick
(10) in the desired direction.
• The desired drilling depth can simply be subtracted fromthe displayed centimeter
number. (Example: 4 cm is displayed on the scale, and you want to drill 2 mm. So the
scale should be adjusted to display 3.8 cm.)
• Lift the depth measuring stick up, so that the read-o point on the scale (a1) shows the
corresponding value. (3.8 cm in the example)
• Now adjust the depth measuring stick (9) with the new calibration. The depth
measuring stick can be locked in position by tightening the set screw (8). You now have
set the desired drilling depth.
• Now loosen the height adjuster (12) to get the mould cutter ready for operation.
Drilling direction
The drilling must always turn in the opposite running direction of the drill counterrotation).
The rotation direction is indicated by the arrow (3) on the front of the machine. See
illustration (H).
Turning On/Off
• To operate the machine, first press and hold the safety latch (16). Then press and hold
the big on/off switch (17). The drill is now turned on.
• As soon as you let go of the on/off switch (17), the drill will turn o. In the case that you
let go of the safety latch (16), the on/off switch (17) will be locked again.
Mould cutting
• Loosen the height adjuster (12) and set the mould cutter on the work piece.
• While operating, press the mould cutter until the height stopper (7) stops.
• Continue pressing the mould cutter and tighten the height adjuster (12) again. Now
push the mould cutter as desired by grasping both router handles.
• To turn the machine o, simply let go of both orange buttons (16, 17) on the right
handle.
• Hold the router firmly until the motor has stopped.
OPERATION