Status BVP300, User Manual

Page: 8 / 12

8
a.) The electric vacuum pump usually needs to be
charged before first use. Prepare the charging
base for charging by plugging the DC connector of
the adapter in the slot. Plug the other end of the
adapter in the socket.
b.) Place the electrical vacuum pump on the charging
base, so the connectors connect and the
tongue sits in the groove. The pump should be
positioned stably in the base. Charging starts
immediately.
c.) The indicator light flashes green during the charging
of the device.
d.) The charging is complete when the indicator light
stops blinking and shines green.
e.) To maintain the optimal functioning of the battery
charge it at least once every 3 to 6 months.
2.1. GENERAL INSTRUCTIONS
a.) Upon removing the electric vacuum pump from
its packaging make sure that all the component
parts are included and that the device and all
its component parts are fully operational. Take
special care to remove all the packaging bits from
the seal.
b.) Make sure you read the user manual thoroughly
before first use and follow the instructions.
2.2. CHARGING
2. USAGE
b.) Press the On/Off button. The pump automatically
sucks the air out of the container.
c.) The indicator lights green during vacuum packing.
d.) The duration of vacuum packing depends on the
size of the container and the amount of food:
vacuum will be created faster in a smaller container
than a larger one, and in a full container than an
empty one.
e.) The pump disengages automatically when the
vacuum pressure in a container reaches the preset
value.
f.) The operation of the pump can be stopped at any
time by pressing the button On/Off.
g.) If the pump’s battery is empty, it will not turn on
upon pressing the On/Off button or the green light
will blink fast. The battery needs to be charged.
h.) In case of incorrect vacuum packing process the
pump automatically turns off after one minute.
After you have acquainted yourself with the general and
safety instructions and you have charged the device,
you can start using gastro vacuum pump in accordance
with the following guidelines.
a.) Vacuum pack by placing the vacuum pump on the
valve at the centre of the lid of a gastro vacuum
container, and press lightly (see the picture below).
Figure 1:
The placement of STATUS Gastro electrical
vacuum pump BVP300 on the STATUS Gastro vacuum
container.
2.3. INSTRUCTIONS FOR USE