STATESMAN XR714W, Instruction Manual

Page: 16 / 20

16
TROUBLESHOOTING - Continued
Buttons on the
appliance not
working.
Child lock has been activated.
This may have been caused by
too much detergent or rinse cycle
taking longer of loaded with too
many garments above the maximum
capacity.
Next time reduce the amount
of detergent or reduce to load
capacity.
Deactivate child lock (see page 10).
Fault Possible cause Solution
Wash time cycle
delay.
Check the drain hose height. Ensure drain hose is between
65cm – 100cm from the floor (see
page 8).
The appliance fills
with water whilst
draining.
Drain hose blocked and immersed
in water.
Check that the hose isn’t blocked.
ERROR DISPLAY CODES
E1
The washer fills over the time
Water drainage over time. Check if the drain pump is blocked.
Contact Statesman Customer Service
Check if the tap is open
Check if the water pressure is too low.
Check if the inlet hose is blocked.
Display Fault Solution
E2
Door lock is broken. Try closing the door firmly again.
Check if any garments are caught
between the door and seal.
Contact a technician
E3
E4
Water has overflowed. Let the appliance drain out water
automatically until the water level is
suitable for wash procedure.
E5
The appliances motor is faulty. Contact Statesman Customer Service
E6
The appliance is not heating up. Contact Statesman Customer Service
E7
Temperature sensor fault. Contact Statesman Customer Service
E9
Communication failures Contact Statesman Customer Service
E10
Inverter failures. Contact Statesman Customer Service
EP
The cycle running does not match
the control dial.
Turn the control dial to the
corresponding cycle.