S
S
V
V
Quality
Digital
Products
S2828+ Quick Tips Guide
This receiver has been preloaded and set for the Optus D1 satellite as used by SKY TV and Freeview New Zealand.
All receivers by Starview have been tested working before leaving our CHCH store.
NO TUNING of the S2828+ is required to get the standard Freeview channels as they have been pre-programed for you.
You should be able to connect to a satellite dish aligned to the satellite and start enjoying digital TV.
However there are many settings with satellite TV so this guide has been written to help with the basics.
If you require more advanced information please refer to the other manual supplied with the S2828+, or you may have
to contact your installation technician or supplier.
We know you will enjoy your Starview S2828+
LNB Frequency's - a quick over view and how to change.
The receiver unit on the end of a satellite dish is called an LNB.
This converts the signal from the satellite to a signal you can send
down coax cable to your satellite receiver.
There are 2 main LNB's used in New Zealand. 11300 & 10750:
The S2828+ has been pre programed for use with the 10750 LNB This
is also the dual or quad LNB’s currently being installed by SKY TV.
Most installations are now using the 10750 LNB ' also called 10.75.
This number is written on most quality LNB's
If you have an older style of LNB it may be a 11300 or 11.3
You will just have to change the LNB setting on the S2828+ to get
signal
NOTE:
If you have pictures then you do NOT need to change this
setting.
To change LNB Frequency
Press ‘MENU’ and select the ‘Installation’ menu
If you are asked for a password the default number is 0000
Select ‘Antenna Setting’ press ‘OK’
Highlight ‘LNB Frequency’
Now you can use LEFT button to allow you to enter the LNB frequency (fig 3)
Press ‘OK’ to save and ‘Exit’ to quit
SCANNING FOR NEW CHANNEL'S
To scan for new channels or channel names that may have
changed on the Freeview network.
Press 'MENU' and select the ‘Installation / Antenna Setting Menu as above.
Press the ‘
BLUE’
button under this menu
Make sure your settings in the scan menu look like (fig 4) then press ‘OK”
www.starview.co.nz
(fig 1)
(fig 2)
(fig 4)
(fig 6)
(fig 3)
(fig 5)
The S2828+ will then start to scan
for channels on known transponders
Once all channels have been scanned
select YES and press ‘OK’ to save
as per (fig 6)