Page 11
12.
Secure the side bed shroud to the
frame using one (1) piece of the M5 x
18mm screw then slide the left side bed
bridge cap (740-9451-XX) into the gap
between the left side bed cover and top
shroud.
13.
Use a #2 phillips screwdriver to secure
the cap to the frame using one (1) piece
of the M5 x 18MM screw. Repeat Steps
11+12 for the right side bed cover and
bridge cap.
Fig. 16
14.
Check to ensure that both left and right
rear feet are attached to the unit. If a
foot is missing, be sure to check the
packaging.
Caution:
Two persons may be
needed to perform this step safely.
Fig. 17
15.
Use a 9/16” open-ended wrench
to adjust both leveling feet until the
treadmill is stable and level. Then use a
3/4” open ended wrench to tighten the
lock nuts to secure the feet.
Fig. 18
